It's a nice touch on EV Cooper.
Are we going to see a brass plaque saying "REBUILT, AVIEMORE, 2021'?
Look at that! How could you not love the Gresley machines when they look this good! Cracking shot!
Pictures as they say. Its not as straightforwards as that because the shaft is constrained at both ends, and the wheel itself does move, it would...
I am not seeing keyways in the Crank Web as suggested. That to me suggests torsion failure. Although the shaft is smaller at the web, there is a...
Do we have enough evidence in timetables and loading's to be able to definitively say this? Its a big ask to get the capital to build 6 new unique...
Its important to note that the key way reduces the area, and subsequently increases the stress for a given load condition. That point of maximum...
Well indeed. We have no evidence to show that P2s spread the track any more than any other machine abs so I don’t see why others are proposing...
But the track on railways does give. Its not totally fixed and does deflect somewhat given the forces it encounters. I hope we are also...
But the track on railways does give. Its not totally fixed and does deflect somewhat given the forces it encounters. Except that it inst and I...
A few points to bear in mind. The P2 axle failures have clear evidence of stress raiser/sharp corners. This has been resolved by the recent P2...
Hopefully someone with the knowledge to answer will chip in.
Pulling some snippets from Wiki. The second locomotive of the class, No.2002 Earl Marischal was completed by 1935, also at Doncaster, and was...
Is the plan for retirement in Fife now off the agenda?
Just a point of order. I’m not sure this is precisely what was meant, but I’d make the argument that Designers and Engineers on this side of the...
The best is an A4. The rest of you can argue among yourselves about second place.
Firstly, I hope they are ok/recovering. Secondly, an impact wrench? Why? They only need to be tightened up by hand with an appropriate socket...
Cracking idea. Then we could call it Maroon 5 and watch it draw in a whole new crowd of enthusiasts.
Would this not be a contradiction in terms? Dimensional instability in cast and welded parts or structures arises due to residual stresses inside...
If nominal TE has little practical application, what is a better metric for comparison?
Separă nume cu o virgulă.
