70013

Santa could at least have left you some coal, Sounds like it will be ready, when its ready, at least it's not been promised on several Railtours, whilst still in bits

 

Now three years on from when it was first estimated to be operational. Any update ? No mention of 70013 at all in the most recent edition of Main Line.

 

I'm led to believe it's currently being worked on in Tyseley.

 

The frame was still at Loughborough a couple of months ago when I visited, boiler at Tyseley as mentioned above.

 

The boiler cladding has been shot blasted and primered in the last week or so, believe Tyseley have just put all of the small tubes into the boiler within the last fortnight and the shed fitters have been doing some work pre-Autumn steam gala on the cylinder chest non-return valves, cylinder main steam pipe studs and a few other smaller items.

Information from the GCR Shed Facebook page who also said back in September that they hope to have the boiler back this year, fit a new ashpan and then drop into the frames.

 

Here is the boiler cladding being worked on in the shed.

 

Know that the NRM arent keen on modifications, but Im sure the Clan chaps would be happy to offer the modified rear cylinder cover/slidebar support pattern if they fancy giving that a go.
Similarly the Lempor drawings...

 

Here is the boiler cladding being worked on in the shed.
浏览附件95226

 

What s used for boiler Lagging these days ? and is there anything to be gained from increasing the thickness of that ?

 

I believe the boiler lagging is fibreglass these days. I suspect there is so much heat lost up the chimney, any extra fibreglass thickness is just extra cost for minimal gain.....plus the appearance would be altered....and eyebrows raised!

 

I think it is mainly trying to keep the boiler temp stable ie when not in steam cooling slowly, there was a time some owners insisted on a chimney cap, and not cleaning the grate and ash pan, not seen it for a while as it can cause other problems.